Redmi 5 Plus Mi Account Remove UMT Dongal Edl Mode

Redmi 5 Plus Mi Account Remove UMT Dongal Edl Mode

1.  Device    : Xiaomi Redmi 5 Plus
   Operation    : Reset Mi Account
   Checking for existing devices...Not Found
   Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
   Some phones may need Special Boot Cable or TestPoint for EDL mode.
   Found Port    : Qualcomm HS-USB QDLoader 9008 (COM27)
   Driver Info    : Qualcomm Incorporated, qcusbser.sys, 2.1.1.0
   Connecting to phone...OK
   Waiting for response...OK
   Init Handshake Sequence...OK
   Hardware ID    : E1600400 [8953] 00000000
   OPK_DATA    : 079E496E26A477B120DFCD85DF7E4AD067164D8292DDD379930D5891E3D8240B
   Initializing Protocol...OK
   Using Auto Loader Selection [1]
   Preparing Firehose Loader...Done
   Sending Loader [8953.ufl]...Done
   Executing Loader...OK
   Detecting Chip Type...OK
   Hardware    : 8953, eMMC, 64 GB
   LU Count    : 1 [0x0747C000]
   WARNING! High Speed Driver is not installed.
   Please install driver from QcFire\Drivers folder using Device Manager.
   Payload Info    : In: 65536 [4096], Out: 1048576, Sector Size: 512
   Reading Partition Table...OK
   Reading Device Information...OK
   Device    : Xiaomi Redmi 5 Plus [msm8953]
   Software    : ZQL1711-vince-build-20180710172756, V9.6.4.0.NEGMIFD [Tue Jul 10 17:27:53 WIB 2018]
   Android Ver.    : 7.1.2
   Patch Level    : 2018-06-01
   Resetting Mi Account Data...Done
   Preparing Data...Done
   Formatting Userdata...Done
   When phone is completely ON, connect to Internet and add Mi Account.
   -------------- INFORMATION --------------
   New Firmware may cause hang on logo.
   In such case, you need to flash phone to recover.
   Or downgrade firmware and try Reset Mi Account again.
   Operation Finished.
   Module Ver. 2.4