Xiaomi Note 5 FRP Remove EDL Mode

Xiaomi Note 5 FRP Remove EDL Mode

1.  Operation    : Reset FRP
   Checking for existing devices...Not Found
   Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
   Some phones may need Special Boot Cable or TestPoint for EDL mode.
   Found Port    : Qualcomm HS-USB QDLoader 9008 (COM15)
   Driver Info    : Qualcomm Incorporated, qcusbser.sys, 2.1.2.7
   Connecting to phone...OK
   Waiting for response...Ignored
   Init Handshake Sequence...OK
   Hardware ID    : E1C00C00 [8996] 00000000
   OPK_DATA    : F7337FE47B192EF4D1BA34CB4E879F0C6B771D06D2DE87BF21F65BA3303834E1
   Initializing Protocol...OK
   Using Auto Loader Selection [1]
   Preparing Loader...Done
   Sending Loader [8996_016]...Done
   Executing Loader...OK
   Detecting Chip Type...OK
   Hardware    : MSM8996, eMMC, 64 GB
   LU Count    : 1 [0x0747C000]
   WARNING! High Speed Driver is not installed.
   Please install driver from QcFire\Drivers folder using Device Manager.
   Payload Info    : In: 65536 [4096], Out: 131072, Sector Size: 512
   Reading Partition Table...OK
   Reading Device Information...OK
   Device    : Xiaomi Redmi Note 5
   Software    : OPM1.171019.011, V10.2.1.0.OEIMIXM [Mon Dec 24 16:11:13 WIB 2018]
   Android Ver.    : 8.1.0
   Patch Level    : 2018-12-01
   Resetting FRP Lock.......Done
   Operation Finished.
   QcFire Ver. 3.3