Xiaomi Note 5 Mi Account Remove EDL Mode

Xiaomi Note 5 Mi Account Remove EDL Mode 
 

1. Operation    : Reset Mi Account
   Checking for existing devices...Not Found
   Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
   Some phones may need Special Boot Cable or TestPoint for EDL mode.
   Found Port
   Driver Info    : Qualcomm Incorporated, qcusbser.sys, 2.1.2.7
   Connecting to phone...OK
   Waiting for response...OK
   Init Handshake Sequence...OK
   Hardware ID    : E1C00C00 [8996] 00000000
   OPK_DATA    : F7337FE47B192EF4D1BA34CB4E879F0C6B771D06D2DE87BF21F65BA3303834E1
   Initializing Protocol...OK
   Using Auto Loader Selection [1]
   Preparing Loader...Done
   Sending Loader [8996_016]...Done
   Executing Loader...OK
   Detecting Chip Type...OK
   Hardware    : MSM8996, eMMC, 64 GB
   LU Count    : 1 [0x0747C000]
   WARNING! High Speed Driver is not installed.
   Please install driver from QcFire\Drivers folder using Device Manager.
   Payload Info    : In: 65536 [4096], Out: 131072, Sector Size: 512
   Reading Partition Table...OK
   Reading Device Information...OK
   Device    : Xiaomi Redmi Note 5
   Software    : OPM1.171019.011, V10.2.1.0.OEIMIXM [Mon Dec 24 16:11:13 WIB 2018]
   Android Ver.    : 8.1.0
   Patch Level    : 2018-12-01
   Resetting Mi Account Data...Done
   Preparing Data...Done
   Formatting Userdata...Done
   When phone is completely ON, connect to Internet and add Mi Account.
   -------------- INFORMATION --------------
   New Firmware may cause hang on logo.
   In such case, you need to flash phone to recover.
   Or downgrade firmware and try Reset Mi Account again.
   Operation Finished.
   QcFire Ver. 3.3